o There are 3 steps to wear:
o Place the sensor: You can hold the implanter, uncover the non-woven tape release paper on the back of the sensor base, be careful not to touch the sticky part with your hands to avoid reducing the stickiness, and then place the sensor horizontally on the abdominal application site. The front end faces the navel, and the fingers are pressed along the non-woven tape to ensure a firm application
o Transplant the sensor: fix the implanter with one hand, then pull out the positioning plate in the direction of the arrow with the other hand to fix the base, and place the index finger and middle finger of the other hand on the top of the guide needle seat, and the two Refers to clamping the housing. Put your thumb on the push rod, push down, and push the push rod all the way in, making sure it's flush with the housing. A clicking sound is heard, indicating that the needle and sensor probe have been implanted. Place the index finger and middle finger under the guide needle seat, move the guide needle seat upward, the direction is as indicated by the arrow in the instruction manual, until you hear a click or can no longer move, squeeze the buckles on both sides of the sensor base with one hand to release the implant remove the released implant with the other hand, the sensor base should now be on the body
o Install the transmitter: place the transmitter in the base of the sensor, fix the transmitter, and make sure to hear a ticking sound, if it is not fully buckled, it may cause the transmitter to detach